Arexons System 56A20 high performance blocker 200°C 50 ml cod. 4748

Arexons System 56A20 high performance blocker 200°C 50 ml cod. 4748

Blocks and seals coaxial cylindrical parts subjected to high temperatures with very high mechanical resistance. Medium viscosity product that allows you to block free-flowing parts as an alternative to interference parts. In interference assembly, the strength of the joint increases approximately 4 times. It allows you to obtain a perfectly distributed load over the entire occupied surface. Eliminates tension inside the joint, protecting it from possible contact corrosion. Permanent locking. Used on threaded parts, it acts as an extremely strong threadlocker. High resistance to water, oils, fuels, hydraulic and refrigerant fluids, gases, vapours. Tested according to DIN 54452 standards. Operating temperature: from -55°C to +200°C. Maximum diametric clearance: 0.25 mm. Storage at room temperature: 18 months minimum.

DESCRIPTION

Specific product for locking and sealing bearings, gears, pulleys, liners, bushings, bushings, pins, keys, pins and other mechanisms in general, even in the presence of high temperatures, with very high mechanical resistance.

Suitable for braking threaded parts with very high mechanical resistance, even at high temperatures.

Product suitable for blocking free-flowing parts also subject to high temperatures.

It allows free-sliding locking as an alternative to interference locking.

Used in interference assembly, it increases the resistance of the joint by approximately 4 times, given the ability to create 100% surface contact, it allows to obtain a perfectly distributed load over the entire engaged area.

Eliminates tension inside the joint, protecting it from possible contact corrosion.

For quick blocking use AP 724 QUICK PRIMER.

USE

Recommended for braking parts not subject to dismantling.

USE

Surfaces must be clean and dry.

We recommend using System MC217.

Apply the product on the bolt in the coupling area with the nut.

For blind holes, apply the product to the bottom of the hole.

Assemble and tighten as required.

Wait for the expected polymerization times before moving the coupling.

For application temperatures lower than +15°C or in case of slow polymerization speed, System AP724 Rapid Primer can be used.

WARNINGS

This product is not normally recommended for use with plastic materials, where stress cracking is possible.

Contact our technical service for prior confirmation of compatibility.