Arexons System 52A70 strong thread lock 10 ml cod. 4700
Arexons System 52A70 strong thread lock 10 ml cod. 4700
For braking studs, nuts and bolts that are not subject to dismantling. Low viscosity product. Eliminates loosening due to vibrations, shocks, temperature changes. Prevents corrosion and seizure. Permanent braking. High resistance to water, oils, fuels, hydraulic and refrigerant fluids, gases, vapours. Tested according to DIN 54454 standards. Operating temperature: from -55°C to +150°C. Maximum diametric clearance: 0.15 mm. Storage at room temperature: 18 months minimum.
Arexons System 52A70 strong thread lock 10 ml cod. 4700
PRODUCT DESCRIPTION
Specific product for the permanent braking of studs, nuts, bolts.
Recommended for braking threaded parts not subject to dismantling.
Low thixotropy product.
Eliminates the use of conventional braking means such as nuts, lock nuts, washers, growers, self-locking nuts.
Avoids loosening due to vibrations, shocks, temperature changes.
It has high resistance to water, oils, fuels, hydraulic and refrigerant fluids, gases and vapours.
Prevents corrosion.
Also suitable for surfaces with a slight presence of oil.
System 52A70 can be used to brake or seal metal components, including stainless steel ones.
It is advisable to use System AP724 Rapid Primer to accelerate the polymerization reaction, which on these types of steel can be excessively slow, and/or in the presence of high clearances.
It is recommended to carry out specific tests according to your procedures and quality standards to verify the suitability of the product for the specific application.
HOW TO USE
Surfaces must be clean and dry.
We recommend the use of Fulcron super degreaser solvent based.
Apply the product on the bolt in the coupling area with the nut.
For blind holes, apply the product to the bottom of the hole.
Assemble and tighten as required. Wait for the times
polymerization times required before moving the coupling.
For application temperatures lower than +15°C or in case of slow polymerization speed, System AP724 Rapid Primer can be used.
TECHNICAL FEATURES
Green colour
Specific gravity 1.10
Viscosity at 25°C (mPa.s) 450-650
Max diametric clearance 0.15 mm
Max thread diameter M20
Resist. residual initial unscrewing (Nm).
Resist. to creep (N/mm2) 25 – 35 50 – 65 – 20
Operating temperature -55°C +200°C
Product tested according to DIN 54454 standards
WARNINGS
This product is not normally recommended for
use with plastics, where possible
stress cracking phenomena. Contact our
technical service for prior confirmation of
compatibility.
STORAGE
Validity of the product after packaging in
sealed package and stored at temperature
environment: 18 months minimum.
Free Shipping Over:
-
149€ 🇮🇹
-
249€ 🇩🇪 🇦🇹
-
299€ 🇧🇪 🇫🇷 🇱🇺 🇳🇱 🇵🇱 🇨🇿
-
349€ 🇩🇰 🇵🇹 🇸🇰 🇪🇸 🇭🇺
-
399€ 🇧🇬 🇭🇷 🇪🇪 🇮🇪 🇱🇻 🇱🇹 🇷🇴 🇸🇮 🇸🇪
-
999£ 🇬🇧 🇨🇭 customs duties included