Arexons System 35A42 hydraulic sealant 250 ml cod. 4730

Arexons System 35A42 hydraulic sealant 250 ml cod. 4730

For sealing threaded joints in hydraulic and pneumatic pipelines up to a diameter of 3/4"" (M20). Anaerobic product with medium mechanical resistance. It guarantees a perfect watertight seal. It increases the structural solidity of the joint and prevents any loosening due to vibration. Protects threads from corrosion. It does not create obstructions in micropassages and does not contaminate hydraulic or pneumatic circuits. Resists hydraulic fluids and gases. The joint can be dismantled with normal tools. Tested according to DIN 54454 standards. Operating temperature: from -55°C to +150°C. Maximum diametric clearance: 0.15 mm. Storage at room temperature: 18 months minimum.

DESCRIPTION

Specific product for sealing threaded joints in hydraulic and pneumatic pipes up to a diameter of 3/4".

Disassembly is possible with normal tools.

Product with medium thixotropy and medium mechanical resistance.

The thixotropic property prevents the treated surfaces from sagging and allows application without waste.

The medium mechanical resistance makes disassembly possible.

It ensures a perfect seal against liquids and gases.

It forms a tough film which increases the structural solidity of the joint.

Protects threads against corrosion and prevents loosening caused by vibration.

It does not create obstructions in the micro passages and does not contaminate the hydraulic or pneumatic circuits.

The anaerobic characteristic, i.e. the fluid state in the presence of air, allows for easy removal of excess product.

For faster sealing we recommend System AP724 Rapid Primer.

USE

Recommended for sealing threaded joints and fittings in general, pipes and containers containing gas, LPG, compressed air, oil and fuel, industrial fluids, CFCs, drinking water and various chemical substances

CLASSIFICATION

Product tested according to DIN 54454 standards

Approved as a sealant for gas tight fittings according to EN751-1 by DIN-DVGW n°NG-5146AU0038 from -20°C to +150°C up to 2” diameter

USE

Before assembling, clean and dry the threads (water, oil or dirt do not guarantee adhesion of the sealant on the threaded parts).

WARNINGS

This product is not normally recommended for use with plastic materials, where stress cracking is possible.

Contact our technical service for prior confirmation of compatibility.