Arexons System 56A48 high temperature blocker 250 ml cod. 4738

Arexons System 56A48 high temperature blocker 250 ml cod. 4738

For locking bearings, bushes, gears, pulleys, liners, bushes, keys, pins, pins and other cylindrical parts not subject to dismantling. For parts subjected to very high temperatures. Low viscosity product. For assembly of free-sliding parts as an alternative to interference assembly. In interference assembly, the strength of the joint increases approximately 4 times. It allows you to obtain a perfectly distributed load over the entire occupied surface. Eliminates tension inside the joint, protecting it from possible contact corrosion. Permanent locking. Used on threaded parts, it acts as an extremely strong threadlocker. High resistance to water, oils, fuels, hydraulic and refrigerant fluids, gases, vapours. Tested according to DIN 54452 standards. Operating temperature: from -55°C to +175°C. Maximum diametric clearance: 0.15 mm. Storage at room temperature: 18 months minimum.

DESCRIPTION

Specific product for all cylindrical parts subjected to shear stress and radial load.

It is used to lock bearings, gears, pulleys, liners, bushings, bushings, pins, keys, pins.

It is suitable for high-strength braking of threaded parts.

Fluid product suitable for blocking free-flowing parts.

It allows free-sliding assembly as an alternative to interference assembly.

Used in interference assembly, it increases the strength of the joint by approximately 4 times, given the ability to create 100% surface contact.

It allows you to obtain a perfectly distributed load over the entire occupied area.

Eliminates tension inside the joint protecting it against possible contact corrosion.

It has high resistance to water, oils, fuels, hydraulic and refrigerant fluids, gases and vapours.

For rapid braking or application at temperatures below +15°C, use System AP724 Rapid Primer.

USE

Recommended for braking parts not subject to dismantling.

USE

Surfaces must be clean and dry.

We recommend using System MC217.

Apply the product on the bolt in the coupling area with the nut.

For blind holes, apply the product to the bottom of the hole.

Assemble and tighten as required.

Wait for the expected polymerization times before moving the coupling.

For application temperatures lower than +15°C or in case of slow polymerization speed, System AP724 Rapid Primer can be used.

WARNINGS

This product is not normally recommended for use with plastic materials, where stress cracking is possible.

Where possible, disassembly is facilitated by heating to 150/250°C.

Contact our technical service for prior confirmation of compatibility.