Arexons System 56A41 fixed bearings 10 ml cod. 4716

Arexons System 56A41 fixed bearings 10 ml cod. 4716

For fixing bearings, bushes, bushes, oil seals, keys, splines and other cylindrical parts subject to possible disassembly. Product with medium thixotropy: does not drip. Improves the reliability of slide or interference mounts. Allows disassembly with normal tools. Prevents contact corrosion. Seals to eliminate any leaks. High resistance to water, oils, fuels, hydraulic and refrigerant fluids, gases, vapours. Tested according to DIN 54452 standards. Operating temperature: from -55°C to +150°C. Maximum diametric clearance: 0.12 mm. Storage at room temperature: 18 months minimum.

DESCRIPTION

Specific product for fixing bearings, bushings, bushes, oil seals, keys, splines and other mechanisms in general.

For all cylindrical parts subjected to shear stress and radial load.

It is recommended for locking parts not subject to dismantling.

Medium thixotropy product.

Increases the reliability of a sliding or interference fit.

Prevents contact corrosion by sealing any leaks.

It has high resistance to water, oils, fuels, hydraulic and refrigerant fluids, gases and vapours.

For rapid braking use “AP 724 Rapid Primer”.

USE

Recommended for braking parts not subject to dismantling.

USE

Surfaces must be clean and dry.

We recommend using System MC217.

Apply the product on the bolt in the coupling area with the nut.

For blind holes, apply the product to the bottom of the hole.

Assemble and tighten as required.

Wait for the expected polymerization times before moving the coupling.

For application temperatures lower than +15°C or in case of slow polymerization speed, System AP724 Rapid Primer can be used.

WARNINGS

This product is not normally recommended for use with plastic materials, where stress cracking is possible.

Contact our technical service for prior confirmation of compatibility.