Grundfos horizontal multistage centrifugal pump CME-A 10-1 cod. 98394928
zoom_out_map
chevron_left chevron_right
-49%

Grundfos horizontal multistage centrifugal pump CME-A 10-1 cod. 98394928

Grundfos horizontal multistage centrifugal pump CME-A 10-1 cod. 98394928

Useful to:

  • Air conditioning - Commercial buildings
  • Pressure Boost - Commercial Buildings
  • Increased water pressure for domestic use
  • District heating
  • Irrigation
  • Desalination
  • Industrial heating
  • Washing and cleaning
  • Industrial water supply
  • Community water supply
  • Water distribution

The CME model is a reliable, quiet and compact horizontal suction pump with integrated frequency converter and intelligent functions. The modular design of the pump facilitates the creation of customized solutions.

€1,131.18 VAT included €2,218.00 -49% €927.20 (VAT excl.)

Extra discount on your cart! Add the product to your cart and discover an additional discount on top of the one already applied.

VAT included
check Available

Are You a Company?

To enable the compilation of all data, check the "Company" option in the "Addresses" tab.

New Products with Warranty

All products on our site are new and covered by warranty.

Description

Grundfos horizontal multistage centrifugal pump CME-A 10-1 cod. 98394928

Model: CME 10-1 ARAE-AQQE UADN

Compact, reliable, horizontal, multistage centrifugal pump with radial inlet and discharge port.

The shaft, impellers and chambers are made of stainless steel.

The inlet and outlet parts are made of cast iron.

The mechanical seal is a special type, unbalanced O-ring.

Pipe connection is by internal Whitworth threads, Rp (ISO 7/1).

The pump is equipped with a 1-phase, permanent magnet, air-cooled synchronous motor.

The motor efficiency is classified as IE5 according to IEC 60034-30-2.

The motor has an integrated frequency converter with PI controller.

This allows fine tuning of the motor speed which, in this way, provides performance adapted to the demands of the plant.

A control panel on the motor terminal box allows setting the required setpoint as well as setting the pump to "Min." or "Max." or "Stop".

The Grundfos Eye indicator on the control panel provides a visual indication of the pump's status:

  • "Ignition": Engine is running (spinning green lights) or not running (steady green lights)
  • "Warning": Engine is still running (spinning yellow lights) or has stalled (steady yellow lights)
  • "Alarm": The engine has stopped (flashing red lights).

Communication with the pump is possible via Grundfos GO Remote (accessory).

The remote control allows you to make further settings and read out various parameters, such as "Actual value", "Speed", "Power consumption" and total "Energy consumption".

The terminal block contains the terminals for the following connections:

  • a dedicated digital input
  • two analog inputs, 0(4)-20mA, 0-5V, 0-10V, 0.5-3.5V
  • 5 V supply voltage for potentiometer and sensor
  • a configurable digital input or open collector output
  • Grundfos digital sensor input and output
  • 24 V supply voltage for the sensors
  • two relay signal outputs (potential-free contacts)
  • GENIbus connection
  • interface for Grundfos CIM fieldbus module.
Data sheet
GRUNDFOS
98394928
5711494280599
Specifications
TECHNIQUES
Pump speed on which the pump data is based 3480 rpm
Nominal flow rate 12 m³/h
Prevalence 19.69m
Impellers 1
Shaft seal code AQQE
Approvals CE, EAC, CURUS, UKCA
Drinking water approvals WRAS, ACS, NSF61
Curve tolerance ISO9906:2012 3B
Pump version TO
Model TO

MATERIALS
Body Pump Cast Iron, EN-GJL-200, ASTM A48-25A
Impeller Stainless steel, EN 1.4301, AISI 304
Material code TO
Rubber code AND

INSTALLATION
Ambient temperature limit -20 .. 55°C
Max operating pressure 10 bars
Max pressure at the quoted temperature 10 bar / 90°C - 10 bar / 90°C
Connection type Rp
Size of the incoming connection 11/2inch
Size of the output connection 11/2inch
Output position 12
Pump connection code R

LIQUID
Pumped liquid Waterfall
Liquid temperature range -20 .. 90°C
Liquid temperature during operation 20°C
Density 998.2 kg/m³

ELECTRICAL DATA
Standard engine IEC
Structure size 80B
Rated power - P2 1.1 kW
Network frequency 50/60Hz
Usable for 50/60Hz Yes
Nominal tension 1 x 200-240V
Rated current 6.70-5.60A
Rated speed 360-3456 rpm
Protection class (IEC 34-5) IP55
Insulation class (IEC 85) f

OTHER
Frequency converter Built-in
Terminal block location 12
Minimum efficiency index, MEI ≥ 0.7
Net weight 23.5kg
Gross weight 25.3kg
No Danish VVS 385224010
Finnish 4925825
Country of origin HU extension
Convention rate n. 8413075
curves
file_1677749912.2578.png
DRAWINGS
file_1677749918.5791.png
Free shipping

Free Shipping Over:

  • 149€ 🇮🇹

  • 249€ 🇩🇪 🇦🇹

  • 299€ 🇧🇪 🇫🇷 🇱🇺 🇳🇱 🇵🇱 🇨🇿

  • 349€ 🇩🇰 🇵🇹 🇸🇰 🇪🇸 🇭🇺

  • 399€ 🇧🇬 🇭🇷 🇪🇪 🇮🇪 🇱🇻 🇱🇹 🇷🇴 🇸🇮 🇸🇪

  • 999£ 🇬🇧 🇨🇭 customs duties included